RADVision Scopia Elite 5100 Series Guida di Installazione Scaricare il pdf (Pagina 18)

Performing Initial Configuration of the SCOPIA Elite MCU | 14

RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.5

Procedure

Step 1 Connect the power cable.

Step 2 Start the terminal emulation application on the PC.

Step 3 Set the communication settings in the terminal emulation application on the PC as follows:

• Baud rate: 9600

• Data bits: 8

• Parity: None

• Stop bits: 1

• Flow control: None

Step 4 Turn on the power to the MCU.

A log of the auto-boot events scrolls across the computer monitor.

Step 5 When the message “Press any key to start configuration” appears on the screen, press any key

within 10 seconds.

The network configuration Main menu appears:

Main menu

N: Configure network port values

P: Change the configuration software password

S: Configure network security mode

T: Configure TFTP servers list

A: Advanced configuration menu

Q: Quit

Note: If you do not press a key before the countdown ends, the device continues its initialization

and you will need to reboot the device to return to the network configuration Main menu.

Step 6 Enter N at the prompt to configure default network port values and press Enter.

Step 7 Enter 2 to change the network configuration.

Step 8 Enter N at the prompt to enable IPv6 in addition to IPv4.

Step 9 Enter N at the prompt to enable IP separation.

Step 10 Enter the IP address you want to assign to the MCU at the Management IP address prompt and

press Enter.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 30 31

Nessun commento

RADVision Scopia Elite 5100 Series Guida di Installazione Pagina 18